Products
Contact us

Add: 39 Tanan Road,Shijiazhuang,China

Website:www.heavypump.com

Postcode:050024

Tel:86-311-85883441   86-311-66175322        

Fax: 86-311-66175433   86-311-85828617

E-mail:  admin@heavypump.com           

               xinda-1@163.com

Robert My status 点击这里给我发消息
Steven My status 点击这里给我发消息
Nancy My status 点击这里给我发消息
Lily My status 点击这里给我发消息
Jianhua Ji My status 点击这里给我发消息
Jessie My status 点击这里给我发消息
Your current location:Home > FAQ

How to remove the slurry impeller correctly?

IMPELLER REMOVAL

       Removing the slurry pump impeller from a slurry pump for routine maintenance can usually be accomplished by securing the impeller against rotation and applying reverse torque to the shaft through a spanner or lever attached to the overhead crane. A few sharp hits with a hammer will generally loosen the plug threads if they have been properly coated with anti-seize and two release gaskets were used. 
       As the wear life of EXCELLENCE wet end parts continues improving, the corresponding maintenance interval increases. Longer life and harsh duty conditions can result in the impeller to lock tighter on the shaft over time and make routine removal difficult.
WARNING!
       Under no circumstances should heat be applied to the impeller! Air and moisture trapped in the internal cavity can expand and cause the impeller to explode!
WARNING!
       Never operate the motor backwards to loosen or remove the impeller! This can result in mechanical damage and possible injury to personnel. Under the condition, when normal maintenance procedures could not remove the impeller, a technique using a drop bar and the impeller inertia can be used to break the threads loose lightly. The end of a weighted bar is lifted and allowed to drop, turning the impeller in the normal operational direction. When the end of the bar hits a stop plate on the floor, the shock of the sudden stop combined with the inertia of the impeller will generally loosen the plug threads.
       Mild steel should be used. Fabricate a plate that bolts to the coupling half or sheave on the pump shaft. This can be made to attach in the gap between the coupling sections. Multiple bolt patterns will accommodate different pumps in the facility. Using a length of beam, plate or steel tubing, add the longest practical arm that will safely rotate from near vertical to the floor or other solid stop point. On the end of the arm add a weight which doubles as an impact face. For most slurry pumps, use about 180kg or a block about 600 x 255 x 150mm. A ring or other release point is installed on top. Be certain that all parts are welded adequately as the impact forces can be severe. If plate is used for the arm, it should have a brace or gussets to prevent bending.
       Use proper safety practices and keep all persons away here. Place a steel plate on the impact area of the floor to avoid any other damage. Verify that the arm will rotate the impeller in the correct direction. Raise the arm with the overhead crane to a near vertical position and release it.
       Allow the arm to drop and hit the plate. It may take multiple hits.
       Once the slurry pump impeller is free to turn on the threads, install the impeller lifting device and complete the removal procedure.

 

 

Copyright@ Shijiazhuang Heavy Pump Company Limited   Fax:86-311-66175433  86-311-85828617

Tel:+86-311-85883441 86-311-66175322   Email:heavypump1@yahoo.com  xinda-1@163.com

Add:39 Tanan Road, Shijiazhuang,China